Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
483
Views
0
Helpful
2
Replies

How to Change Utilization Threshold

Go to solution
russnash
Level 1
Level 1

‎11-14-2008 08:21 AM

The current utilization threshold in DFM is at 40% for router's where can this vailue be increased?

Labels:
0 Helpful
1 Accepted Solution

Accepted Solutions

Go to solution
Joe Clarke
Cisco Employee
Cisco Employee

‎11-14-2008 08:35 AM

To increase this, go to DFM > Configuration > Polling and Thresholds > Managing Thresholds. Then, select DFM > System Defined Groups > Interface Groups > Serial, and click Edit. Adjust the Utilization threshold, then click Save, then click OK. Then go to Apply Changes, and apply your changes.

View solution in original post

0 Helpful
2 Replies 2

Go to solution
Joe Clarke
Cisco Employee
Cisco Employee

‎11-14-2008 08:35 AM

To increase this, go to DFM > Configuration > Polling and Thresholds > Managing Thresholds. Then, select DFM > System Defined Groups > Interface Groups > Serial, and click Edit. Adjust the Utilization threshold, then click Save, then click OK. Then go to Apply Changes, and apply your changes.

0 Helpful

Go to solution
russnash
Level 1
Level 1
In response to Joe Clarke

‎11-14-2008 08:38 AM

found it!!! Was in the neighborhood.

thanks for all tour help!!

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents