Qos Config issue

Unanswered Question
Nov 14th, 2008
User Badges:
  • Bronze, 100 points or more

I'm trying to do traffic shaping for one of my customer connected thru a VLAN subinterface

. the following is the configuration , but as per the SNMP graph the traffic is exceeding

the limit specified by the configuration


acess-list 100 permit ip any any


class-map match-all any

match access-group 100


policy-map 34Meg

class any

police 34816000 conform-action transmit exceed-action drop


policy-map 34Megd

class any

shape average 34816000


interface GigabitEthernet0/3.243

encapsulation dot1Q 243

ip address 10.10.20.1 255.255.255.252

service-policy input 34Meg

service-policy output 34Megd


Regards

Haris

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
mchin345 Thu, 11/20/2008 - 15:10
User Badges:
  • Silver, 250 points or more

Yes, this configuration will work fine. Remove the config. Reboot the device & configure again Traffic shaping allows you to control the traffic going out an interface in order to match its flow to the speed of the remote target interface and to ensure that the traffic conforms to policies contracted for it. Thus, traffic adhering to a particular profile can be shaped to meet downstream requirements, thereby eliminating bottlenecks in topologies with data-rate mismatches.


Actions

This Discussion