Pickup between PBX and CCM 6.1(2)

Answered Question
Nov 17th, 2008

Hello,

i have a CCM 6.1(2) that communicates with a PBX Bosch Tenovis integral 33 via PRI/MGCP in QSIG.

I would like to know if there is a way to pickup a call of Bosch's phone from an IP phone and viceversa.

Someone have experience of this, any idea?

Thanks a lot.

I have this problem too.
0 votes
Correct Answer by Tommer Catlin about 8 years 3 weeks ago

Call Pickup specific to the PBX the phone is configured for. Features typically do not cross PBXs when a tie line is used such as QSIQ. The communications is typically only in/out calls, caller ID, calling headers (in the data packet of qsiq for cfwd, ring no answer, etc)

Features that are wanted do not traverse in the QSIQ trunk.

Im not even sure you could do a call pickup group between CUCM clusters.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Tommer Catlin Mon, 11/17/2008 - 11:48

Call Pickup specific to the PBX the phone is configured for. Features typically do not cross PBXs when a tie line is used such as QSIQ. The communications is typically only in/out calls, caller ID, calling headers (in the data packet of qsiq for cfwd, ring no answer, etc)

Features that are wanted do not traverse in the QSIQ trunk.

Im not even sure you could do a call pickup group between CUCM clusters.

Actions

This Discussion