WLAN DMZ on Cisco 877

Unanswered Question
Nov 17th, 2008


I have a pretty basic setup with an cisco 877 for routing our lan over adsl. Now we want to have an public wlan available in our shop. I think I need to set-up an 2nd vlan, and use that with Eth3 to hook up the accesspoint. Can anyone explain me the steps to create an dmz set-up on the 877 for this? I'm only beginner in cisco configs.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 2 (1 ratings)
aghaznavi Fri, 11/21/2008 - 14:36

The connection to the Internet is over a serial line. Ethernet 0 is connected to the internal network (a single LAN). Ethernet 1 is connected to a DMZ network, which has a single node used to provide services to the outside world. The ISP has assigned the company the netblock This is equally split between the DMZ and the internal LAN with subnet mask

For further information about configure DMZ interface click this link.



This Discussion