cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
769
Views
0
Helpful
3
Replies

Operation State Down, Cause=Max Retrasmission

libra_lin
Level 1
Level 1

Hello,

My setup:

WLC 4402

1131 Access points

Problem: Sometimes AP radios are shutdown

Trap Logs show this:

AP's Interface:0(802.11a) Operation State Down: Base Radio MAC:00:21:55:ac:29:40 Cause=Max Retrasmission

AP's Interface:0(802.11b) Operation State Down: Base Radio MAC:00:21:55:ac:29:40 Cause=Max Retrasmission

what's cause and how to sovle this problem?

TKS!

3 Replies 3

l.mourits
Level 5
Level 5

Hi,

Not sure if this goes for you, but I've seen similar messages when I had H-REAP configured LAPs controlled by a remote controller, where the round trip delay exceeded the 120ms (as mentioned in the design guide 120ms is the max RTD between LAP and Controller).

HTH,

Leo

Yes, our problem same with you. could you tell me how to solve this problem. TKS!

I had to install a controller in a location closer by, with a better round trip delay between controller and access-point to get this resolved.

After I installed the controller with less then 120ms RTD to the APs, the problem was gone.

HTH,

Leo

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card