Configure AS2511-RJ45 Access Server

Unanswered Question
Nov 17th, 2008

Hello Everyone

So, I just got my AS2511-RJ45 and dont have a clue how to configure it, so I have been searching.

Please note that this device does not use an octal cable, it had 16 RJ45 Async ports.

All the config help i have found is for the one with the octal cable.

Please help

Clueless

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
didyap Mon, 11/24/2008 - 07:27

To configure multiple asynchronous interfaces at the same time (with the same parameters), you can assign each asynchronous interface to a group and then configure the group. Configurations throughout this guide configure group asynchronous interfaces, rather than configuring each interface separately.

For the configuration following URL may help you

http://www.cisco.com/en/US/docs/ios/12_0/dial/configuration/guide/dcmodem.html#wp8562

Actions

This Discussion