11-18-2008 11:30 AM - edited 03-15-2019 02:37 PM
Need some insight on how to configure T1 CAS for international calls outgoing.
Dial-peer configuration is as follows:
dial-peer voice 120 pots
description International
numbering-type international
destination-pattern +011T
port 0/1/0:1
forward-digits all
Using CM 4.2 with a route pattern 9.011!#
discard digits predot Trailing-#.
we also tried adding a route filer to the pattern to include the international access, country code, etc.
We are Receiving a busy signal.
Also when dialing through the gateway it does not show any matching dial-peer.
Thank you for the assist
11-18-2008 12:16 PM
Change your dial peer to:
destination-pattern 011T
Brandon
11-18-2008 12:43 PM
Thank you for the quick response. We made this change and added the "^". This has fixed the connection issue.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: