3Com bridges working with LWAPP

Unanswered Question
Nov 18th, 2008

3Com CB3000 not working in a Cisco LWAPP environment latest software version . We are using tkip tls and the bridge will not always respond to the controller passing on the authentication. The cb3000 is running firmware code version 2.2.2. do you have any issues working with a Cisco LWAP protocol?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
scottmac Wed, 11/19/2008 - 06:23

Unless your 3COM device is operating as a client (to the LWAPP), I'd be surprised that it worked at all.

Wireless bridging is not standardized so it's pretty rare (if at all) that a bridge from one vendor would work with a bridge from another. They all use their own variations of a base protocol (like 802.11a/b/g), but accommodations are made for timing delay and other conditions found in a bridged environment that wouldn't normally exist in a AP/Client session.

Since they are all doing it their own way, it's unusual that one guy's stuff can work with another guy's stuff.

Any additional details you can offer would help ...

Good Luck

Scott

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode