snmp linkdown traps

Answered Question

Hi,


Is there any way to force a switch to only send linkdown traps for specific ports?

Do you just disable linkdown snmp in the global config then enable it on the port?


Matt

Correct Answer by Joe Clarke about 8 years 8 months ago

Switches are typically easier because you have the interface range command. Additionally, with a tool like CiscoWorks Resource Manager Essentials, you can deploy this change across a large number of switches quickly.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Joe Clarke Wed, 11/19/2008 - 09:44
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    Founding Member

Other way around. Enable the traps globally, then configure:


no snmp trap link-status


Under the interfaces you do not wish to send traps.

Correct Answer
Joe Clarke Wed, 11/19/2008 - 09:51
User Badges:
  • Cisco Employee,
  • Hall of Fame,

    Founding Member

Switches are typically easier because you have the interface range command. Additionally, with a tool like CiscoWorks Resource Manager Essentials, you can deploy this change across a large number of switches quickly.

Actions

This Discussion