HWIC-AP Installation into 2811

Unanswered Question
Nov 19th, 2008
User Badges:

Hi,

Kindly help me on how to configure my HWIC-AP wireless card into a 2811 ISR.

The HWIC-AP is already installed in the router. My running config is shown below:


interface Dot11Radio0/3/0

no ip address

shutdown

speed basic-1.0 basic-2.0 basic-5.5 6.0 9.0 basic-11.0 12.0 18.0 24.0 36.0 48.0

54.0


Regards,


Law

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 4 (1 ratings)
Loading.
jeff.kish Wed, 11/19/2008 - 05:48
User Badges:
  • Silver, 250 points or more

Well, I don't know how many SSIDs you want, and what VLANs you're using, so I'll assume a single SSID on the native VLAN. I also don't know what type of encryption you want, so I'll assume none for now. Finally, do you want the SSID to broadcast? I'll assume yes for testing purposes.


To create a broadcast SSID without encryption, perform the following configuration:


conf t

dot11 ssid ssid_name

authentication open

guest-mode


To configure the Radio, perform the following configuration:


conf t

int dot0/3/0

ssid ssid_name

channel 1

bridge-group 1

no shut


Finally, add an IP address on your BVI:

int bvi1

ip add x.x.x.x x.x.x.x


This should be good for testing purposes - let me know if it works. If you want encryption, more VLANs, etc... just post up and someone will be glad to help!

sr2470182 Wed, 11/19/2008 - 06:24
User Badges:

Thanks a million Jeff,


However when I tried to add an IP address into my BVI interface, I received the following error message:


"Integrated Routing and Bridging is not configured"


What should I do please?

sr2470182 Wed, 11/19/2008 - 08:02
User Badges:

Hi,


I added the following command:

"bridge irb"

and I can now configure the BVI1 interface...


Thanks.

jeff.kish Wed, 11/19/2008 - 11:08
User Badges:
  • Silver, 250 points or more

Ah yes, I left that command out. Sorry, it's been a while since I configured one of those.


Glad it's working!

Actions

This Discussion