11-19-2008 09:47 AM - edited 03-04-2019 12:24 AM
I have a 2600 router and want to connect it to my ISP, how do I config.. the interface to use the ISP DHCP?
Solved! Go to Solution.
11-19-2008 10:30 AM
If all you need is an IP address from your ISP on your router then yes.
Mark
11-19-2008 09:55 AM
Shane,
You should configure the port connected to your ISP with the following interface command (ip address dhcp".
HTH,
Mark
11-19-2008 10:18 AM
and that is the only command I should put on the interface?
11-19-2008 10:30 AM
If all you need is an IP address from your ISP on your router then yes.
Mark
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: