11-19-2008 11:16 AM - edited 03-15-2019 02:39 PM
All,
I am wondering if CME POTS dial-peer has '#' sign as its default termination key.
I found in CME VOIP dial-peer, it will recognize '#' as default termination key which stop T302 timeout timing.
ie, I have dial-peer voice 999 voip
destiantion-pattern 25T
when I dial '2550#' in one of ephone, it will ring remote x2500 immediately.
For POTS dial-peer, I cannot confirm '#' sign as default key.
Can anyone confirm for me?
This will affect the dial-peer setup.
Solved! Go to Solution.
11-19-2008 11:59 AM
Yes, # is the termination character for POTS dial peers when using T in the destination pattern.
http://www.cisco.com/en/US/tech/tk652/tk90/technologies_tech_note09186a008010fed1.shtml
Hope this helps.
Brandon
11-19-2008 11:59 AM
Yes, # is the termination character for POTS dial peers when using T in the destination pattern.
http://www.cisco.com/en/US/tech/tk652/tk90/technologies_tech_note09186a008010fed1.shtml
Hope this helps.
Brandon
11-20-2008 07:45 AM
Great - good man Brandon.
thanks - also rate for 5.
In summary:
By default both CCM and CME/SRST IOS support '#' sign as termination for timer.
In CCM, it works with wildcard '!' and '@'.
In IOS, it works with 'T'.
James
11-20-2008 07:56 AM
James,
You are correct. Thanks for the rating.
Brandon
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: