ERROR:- Cannot upload the config of WLC.

Answered Question
Nov 20th, 2008

Hi,

I am not able to save the config on wcs of wlc controller plz have a look and suggest me if i am doing anything wrong here.

(WiSM-slot1-2) >transfer upload mode tftp

(WiSM-slot1-2) >transfer upload datatype config

(WiSM-slot1-2) >transfer upload serverip 10.10.10.10

(WiSM-slot1-2) >transfer upload path /

(WiSM-slot1-2) >transfer upload filename WLCconfig

(WiSM-slot1-2) >transfer upload start

Mode............................................. TFTP

TFTP Server IP................................... 10.10.10.10

TFTP Path........................................ /

TFTP Filename.................................... WLCconfig

Data Type........................................ Config File

Encryption....................................... Disabled

*** WARNING: Config File Encryption Disabled *****************************************************

Are you sure you want to start? (y/N) y

TFTP Config transfer starting.

Error while preparing for transfer!

NOTE: I am using the WCS as the server and not using any other tftp. Any help would be appricaited.

I have this problem too.
0 votes
Correct Answer by inayathulla1 about 8 years 1 month ago

Hi Neha,

You need to reboot the WLC controller if the WLC is placed on the WISM Module you need to reload the WISM module after that you will be able to upload and upgrade the firmware on the controller.

This is happening due to some internal isue with the WISM/WLC hardware. I request you to do this and your problem will be solved.

Regards,

Inayath

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
jeff.kish Thu, 11/20/2008 - 06:37

Check your TFTP server for errors, just in case the filename or directory are wrong. If the TFTP server has no errors, there's probably something wrong with the information entered.

nehakulsum Thu, 11/20/2008 - 06:40

Hey,

Thanks guys for the prompt answer.

To let you know i have other wlc connected to the wcs i have upload the config the same way without any issue only this controller i am having the issue.

any thing else to be checked on this controller.?????

jeff.kish Thu, 11/20/2008 - 06:43

I can't think of any other settings off-hand. Have you tried it from the GUI yet? Maybe try that to see if there's something you're missing from the console configuration.

Correct Answer
inayathulla1 Tue, 12/02/2008 - 06:10

Hi Neha,

You need to reboot the WLC controller if the WLC is placed on the WISM Module you need to reload the WISM module after that you will be able to upload and upgrade the firmware on the controller.

This is happening due to some internal isue with the WISM/WLC hardware. I request you to do this and your problem will be solved.

Regards,

Inayath

nehakulsum Tue, 12/02/2008 - 08:41

Hi Inayath,

After rebooting the WISM module i am able to upload and upgrade the software on the WLC.

Regards,

Neha.

Actions

This Discussion