DHCP on WAP

Unanswered Question
Nov 21st, 2008

Hi All,

Please how can I configure DHCP on my Wireless Access Point network, so that the client PC's can always Acquire Network Addresses from it when connecting: Please find my config below:

no aaa new-model

dot11 syslog

!

dot11 ssid ************

authentication open

guest-mode

interface Dot11Radio0/3/0

no ip address

!

ssid *********

!

speed basic-1.0 basic-2.0 basic-5.5 6.0 9.0 basic-11.0 12.0 18.0 24.0 36.0 48.0

54.0

channel 2412

station-role root

bridge-group 1

bridge-group 1 subscriber-loop-control

bridge-group 1 spanning-disabled

bridge-group 1 block-unknown-source

no bridge-group 1 source-learning

no bridge-group 1 unicast-flooding

Thank you all!

Law

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
John Blakley Mon, 11/24/2008 - 06:49

You should be able to do it like this:

ip dhcp pool WIRELESS

network 192.168.100.0 255.255.255.0

default-router 192.168.100.1

dns-server 4.2.2.1

int do0/3/0

ip address 192.168.100.1

To exclude addresses from the scope:

ip dhcp exclude 192.168.100.1 192.168.100.99

This would allow 192.168.100.100 - .254 to be assigned.

HTH,

John

Actions

This Discussion