Disable the mode option on the switch

Unanswered Question
Nov 21st, 2008

I have a 2960G switch I would like to disable the mode option on the switch how can I do that?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
andrew.butterworth Fri, 11/21/2008 - 08:34

I assume you mean the 'mode' button on the front of the switch that allows you to cycle though the port status, speed, duplex and PoE? If that's the case it can't be disabled for this function, however you can disable the feature where the switch will reset to defaults if the button is pressed for 10-seconds using the commands 'no setup express'

http://www.cisco.com/en/US/docs/switches/lan/catalyst2960/software/release/12.2_44_se/command/reference/cli2.html#wp8240764

HTH

Andy

Actions

This Discussion