11-21-2008 07:34 AM - edited 07-03-2021 04:48 PM
Hi,
Has anybody configure secure mobility groups on 4402/4404. I put mobility secure-mode enable command on both controllers. Mobility Protocol Port status has change to 16667 (after reboot) but I have Data Path Down. Do I have to configure something more? I do not have firewall between controllers.
Without secure mode everything is OK.
One more I thing that 2106 do not support this future.
Cheers
Greg
11-27-2008 11:09 AM
To configure the secure mode for mobility messages between Cisco Wireless LAN controllers/appliances, use the config mobility secure-mode command.
config mobility secure-mode {enable | disable}
Examples
> config mobility secure-mode enable
Related Commands
show mobility summary
11-27-2008 01:54 PM
Also make sure you enter config certificate compatibility on. Secure mode doesn't work on I think 4.2.... I remember trying to enable it on an install.
11-27-2008 11:44 PM
Hi,
Yes I found this command (certificate...) a couple of days earlier. But forget to mention. You were first, so 5 for you.
Did not have time to check whether this command runs.
Cheers
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: