CUCM 7 on IBM x346

Answered Question
Nov 21st, 2008
User Badges:
  • Silver, 250 points or more

Hello,


I have been looking for some data sheets on Cisco.com in regards to upgrading a existing CCM 4.2(3) to CUCM 7. Specifically I'm looking to find out if the IBM x346 series server will support CUCM 7.


Anyone know?


I have found this link but it doesn't state if it supports version 7.


http://www.cisco.com/en/US/prod/collateral/voicesw/ps6790/ps5748/ps378/product_solution_overview0900aecd80091615.html


Regards,

Justin

Correct Answer by Rob Huffman about 8 years 6 months ago

Hi Justin,


Have a look at Table 3 in this good doc :)


Cisco Unified Communications Manager Server Support Matrix


http://www.cisco.com/en/US/prod/collateral/voicesw/ps6790/ps5748/ps378/prod_brochure0900aecd8062a4f9.html


Hope this helps!

Rob


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Rob Huffman Fri, 11/21/2008 - 08:48
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Hi Justin,


Have a look at Table 3 in this good doc :)


Cisco Unified Communications Manager Server Support Matrix


http://www.cisco.com/en/US/prod/collateral/voicesw/ps6790/ps5748/ps378/prod_brochure0900aecd8062a4f9.html


Hope this helps!

Rob


Justin Brenton Fri, 11/21/2008 - 08:53
User Badges:
  • Silver, 250 points or more

RRR I was so close and missed that doc..... Thanks Rob... ;) This is exactly what I was looking for...

Rob Huffman Fri, 11/21/2008 - 10:48
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Hi Justin,


You are most welcome! In the 80 Zillion docs here it's hard to find the one you want sometimes.


Cheers!

Rob

Justin Brenton Mon, 11/24/2008 - 15:59
User Badges:
  • Silver, 250 points or more

Hi Rob,

The IBM xSeries 346 that I'm trying to see if supports CUCM 7 is not listed as the server contains a 2.8 ghz intel xeon processor


My server specs:

IBM x346

Intel Xeon 2.8 ghz processor

2 x 70gb HD

2Gb RAM


Any idea's?



Rob Huffman Tue, 11/25/2008 - 06:24
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Hi Justin,


You do seem to meet the minimum spec's for a CCM 7.0(1) build;


Cisco Unified CM requires a minimum of 2 GB of memory, 72 GB disk drive, and 2 GHz processor.


http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/rel_notes/7_0_1/cucm-rel_notes-701.html#wp579941


But, I would be hesitant to proceed without verification from TAC that this will be a supported install. You might also want to engage your Cisco SE to do some research here as well.


Hope this helps!

Rob

Actions

This Discussion