Solved: CUCM 7 on IBM x346

Justin Brenton · ‎11-21-2008

Hello,

I have been looking for some data sheets on Cisco.com in regards to upgrading a existing CCM 4.2(3) to CUCM 7. Specifically I'm looking to find out if the IBM x346 series server will support CUCM 7.

Anyone know?

I have found this link but it doesn't state if it supports version 7.

http://www.cisco.com/en/US/prod/collateral/voicesw/ps6790/ps5748/ps378/product_solution_overview0900aecd80091615.html

Regards,

Justin

Rob Huffman · ‎11-21-2008

Hi Justin,

Have a look at Table 3 in this good doc :)

Cisco Unified Communications Manager Server Support Matrix

http://www.cisco.com/en/US/prod/collateral/voicesw/ps6790/ps5748/ps378/prod_brochure0900aecd8062a4f9.html

Hope this helps!

Rob

View solution in original post

Rob Huffman · ‎11-21-2008

Hi Justin,

Have a look at Table 3 in this good doc :)

Cisco Unified Communications Manager Server Support Matrix

http://www.cisco.com/en/US/prod/collateral/voicesw/ps6790/ps5748/ps378/prod_brochure0900aecd8062a4f9.html

Hope this helps!

Rob

Justin Brenton · ‎11-21-2008

RRR I was so close and missed that doc..... Thanks Rob... ;) This is exactly what I was looking for...

Rob Huffman · ‎11-21-2008

Hi Justin,

You are most welcome! In the 80 Zillion docs here it's hard to find the one you want sometimes.

Cheers!

Rob

Justin Brenton · ‎11-24-2008

Hi Rob,

The IBM xSeries 346 that I'm trying to see if supports CUCM 7 is not listed as the server contains a 2.8 ghz intel xeon processor

My server specs:

IBM x346

Intel Xeon 2.8 ghz processor

2 x 70gb HD

2Gb RAM

Any idea's?

Rob Huffman · ‎11-25-2008

Hi Justin,

You do seem to meet the minimum spec's for a CCM 7.0(1) build;

Cisco Unified CM requires a minimum of 2 GB of memory, 72 GB disk drive, and 2 GHz processor.

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/rel_notes/7_0_1/cucm-rel_notes-701.html#wp579941

But, I would be hesitant to proceed without verification from TAC that this will be a supported install. You might also want to engage your Cisco SE to do some research here as well.

Hope this helps!

Rob