LWAPP Ap boot problem

Unanswered Question
Nov 22nd, 2008

I have a 1252 Ap that was booting to LWAPP software and connecting to a 4402 controller. It suddenly stopped booting into the LWAPP code. I can reach the Ap by telnet and it seems to boot to Autonomous mode. Is there any way to start the boot into LWAPP from the command prompt? Thanks in advance.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Vinay Saini Sun, 11/23/2008 - 08:48

Are you sure AP turned to Autonomous from LWAPP ... that;s weird ..

Can u run folowing cmds on AP

1. Debug lwapp client events

2. show lwapp client rcb

Just wanted to make sure it is not lwapp :)



darrell.lewis Sun, 11/23/2008 - 18:34

I've figured out the problem....One of my partners reloaded the Ap with Autonomous code which explains why it was autonomous. I knew it just doesn't happen. Thanks.


This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode