11-22-2008 11:44 PM - edited 07-03-2021 04:48 PM
I have a 1252 Ap that was booting to LWAPP software and connecting to a 4402 controller. It suddenly stopped booting into the LWAPP code. I can reach the Ap by telnet and it seems to boot to Autonomous mode. Is there any way to start the boot into LWAPP from the command prompt? Thanks in advance.
11-23-2008 08:48 AM
Are you sure AP turned to Autonomous from LWAPP ... that;s weird ..
Can u run folowing cmds on AP
1. Debug lwapp client events
2. show lwapp client rcb
Just wanted to make sure it is not lwapp :)
Thanks
Vinay
11-23-2008 11:30 AM
Both commands come back as invalid. I'm also sitting at an ap# prompt.
11-23-2008 06:34 PM
I've figured out the problem....One of my partners reloaded the Ap with Autonomous code which explains why it was autonomous. I knew it just doesn't happen. Thanks.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide