Am upgrading my cisco MDS9513 firmware from 3.0.2(b) to 3.2.3(a)..I get following errors when i start the installation,have done installation successfully on other switches,but this switch in particular throws the error.
Appreciate your help..Thanks
Setting boot variables.
[# ] 0% -- FAIL. Return code -1.
Install has failed. Return code 0x4093000C (Setting boot variables failed).
Please identify the cause of the failure, and try 'install all' again.
Most of the time this is caused by a syntax issue with the 'install all' command.
Please ensure that the kickstart and main SAN-OS image are on the active supervisor bootflash and then issue this command from the command line.
install all system bootflash:m9500-sf2ek9-mz.3.2.3a.bin kickstart
Follow the prompts and at some point you will need to enter Y to continue.
I have seen where the module number, or sup-local was used in the install command and it caused problems.
Hope this helps,