11-25-2008 12:47 AM - edited 03-06-2019 02:39 AM
Hi,
I have configured core sw as root bridge for VLAN 64 (4096).
Core sw config:
spanning-tree vlan 64 priority 4096
I have checked the root bridge for VLAN 64 from access switch
ACC-SW1#sh spanning-tree vlan 64
VLAN0064
Spanning tree enabled protocol rstp
Root ID Priority 4160
Address 0012.00d0.1100
Cost 3
Port 56 (Port-channel1)
Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec
Bridge ID Priority 32832 (priority 32768 sys-id-ext 64)
Address 0023.ab2a.c280
Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec
Aging Time 300
Interface Role Sts Cost Prio.Nbr Type
---------------- ---- --- --------- -------- --------------------------------
Po1 Root FWD 3 128.56 P2p
My question is why it is showing rott bridge as 4160..it suppose to show 4096 right??
Regards
sateesh
11-25-2008 01:01 AM
Hi,
The priority is Priority 4096 + Vlan ID=4096 + 64.
That is the extended system id.
If you want disable it, you must issue the command:
no spanning-tree extend system-id
I hope this helps.
Best regards.
Massimiliano.
11-25-2008 02:29 AM
Hi,
Thanks for prompt response. I have tried in the same way..But still its showing like that only..
Regards
sateesh
11-25-2008 02:33 AM
Hi,
You have to issue this command on root bridge.
Best regards.
Massimiliano.
11-25-2008 02:48 AM
HI,
I have issued the command on root bridge only and rebooted also
Still its like that..
Regards
sateesh
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: