CME STCAPP feature code on FXS port

Unanswered Question
Nov 25th, 2008
User Badges:

Hi,


I am trying to configure the feature access code for FXS port in the same CME. I try to follow "Configuring FXS Ports for Basic Calls" http://www.cisco.com/en/US/docs/ios/voice/fxs/configuration/guide/fxsbasic.html, I met a problem. In order to enable service stcapp in the dial-peer, I need to remove the destination-pattern command. After I remove the destination-pattern and enable the service stcapp, CME does not allow me to add back destination-pattern. Thus if I can't enable the destination-pattern, how I could tell the CME to route the call to that FXS port? I also try the answer-address, changing the incoming called-number pattern and adding back the station-id in voice port, but I am getting busy tone.


I would like to check does anyone have any idea on how to successfully enable the feature access code on the FXS port on the same CME?


Thanks.


Hung.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
ivillegas Tue, 12/02/2008 - 13:24
User Badges:
  • Silver, 250 points or more

To configure feature mode for SCCP analog phones on a Cisco voice gateway and enable SCCP analog phones to invoke features using standard FACs after hook flash, perform the following steps.

enable

configure terminal

stcapp call-control mode feature

end

Configuring Feature Mode:

http://www.cisco.com/en/US/docs/ios/voice/fxs/configuration/guide/fxsfeatmd.pdf

Actions

This Discussion