cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2156
Views
0
Helpful
5
Replies

Line VTY change to login from no login and can't go telnet in now..

cindylee27
Level 1
Level 1

Hi Experts,

After i change from option A to B, I can't seems like telnet to the switch anymore. It prompts for password: ,

and i put in password "cisco" base on the password set below at the line vty, but still can't go in.

Need your advise.

OPTION A

---------

line vty 0 1

exec-timeout 5 0

password 7 14141B180F0B6A

no login

OPTION B

---------

line vty 0 1

exec-timeout 5 0

password 7 14141B180F0B6A

login

Thanks,

cindy

5 Replies 5

satish_zanjurne
Level 4
Level 4

Hi Cindy,

1.Looks like you have mistyped the password while setting it.

2.Try "cisco K" instead of just "cisco".

3.If it does not work , then you need to manually reset the password through console, see below commands

line vty 0 4

login

password cisco123

HTH...rate if helpful..

Yeah,now at remote side..if really can't do it thru telnet , then will need to go down..

I have tried "cisco K",

ciso _space_ K , right? and the "K" is capital letter ya?

If this works, really something interesting ..:)

Thanks again !

cindy

vassiliev
Level 1
Level 1

by the way, did you set enable password?

line vty 0 1

login

device need to check enable password.

Best Regards

Cheng

You mean enable secret password right?

I have set that already..

Em.....it is.....Em....change your password by console...~!

-_-!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: