per-user microflow policing policies support

Unanswered Question
Nov 26th, 2008


Can anyone tell me if Supervisor Engine 720 Version 12.2(18)SXF8 fiber port supports qos trust and service-policy on the interface at the same time? I have this setup at the moment and the "show policy-map interface gig5/1" doesn't give me any hits on my policy is the trust command taking preference in this case?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
ajagadee Wed, 11/26/2008 - 04:33


I believe the "show policy-map int xxxxx" is only when packets are software switched. Since, this is a SUP720, can you do a "show mls qos ip gig xxxxx" and check for hits.

Also, can you post the configuration from the interface. If memory serves, I think qos trust dscp takes precedence over policy map and you can only make use of one. But, this needs lab validation.



*Pls rate if it helps*

770801tvdhaar Wed, 11/26/2008 - 06:32

I have both trust and a service policy attched to the interface and here is the output of a show mls qos ip interface gig5/1

65kaapp0019#show mls qos ip gigabitEthernet 5/1

[In] Policy map is PER-USER-POLICING [Out] Default.

QoS Summary [IPv4]: (* - shared aggregates, Mod - switch module)

Int Mod Dir Class-map DSCP Agg Trust Fl AgForward-By AgPoliced-By

Id Id


Gi5/1 5 In VOIP 0 0* dscp 1 34676045422 0

Gi5/1 5 In CALL-SIGNA 0 0* dscp 2 34676045422 0

Gi5/1 5 In CITRIX 0 0* dscp 3 34676045422 0

Gi5/1 5 In MANAGEMENT 0 0* dscp 3 34676045422 0

Gi5/1 5 In BEST-EFFOR 0 0* dscp 4 34676045422 0


This Discussion