Solved: How to upgrade the ROM: System Bootstrap, Version?

ifabrizio · ‎11-26-2008

Dear All,

I need to know how to upgrade the system bootstrap image on 6506-E with two rendundant sup32-ge-3b?

Thanks & Regards,

Igor.

aghaznavi · ‎12-02-2008

Before upgrading Verify the minimum amount of DRAM, flash memory and Boot ROM version necessary for the new software release. Check whether your switch supports the requirements. Refer to Release Notes for Catalyst 6000/6500 Series Switches in order to verify the requirements for the new software image.

Here is the link for Upgrade bootstrap image on 6500 series.

http://www.cisco.com/en/US/products/hw/switches/ps708/products_configuration_example09186a0080116ff0.shtml#req

View solution in original post

aghaznavi · ‎12-02-2008

Before upgrading Verify the minimum amount of DRAM, flash memory and Boot ROM version necessary for the new software release. Check whether your switch supports the requirements. Refer to Release Notes for Catalyst 6000/6500 Series Switches in order to verify the requirements for the new software image.

Here is the link for Upgrade bootstrap image on 6500 series.

http://www.cisco.com/en/US/products/hw/switches/ps708/products_configuration_example09186a0080116ff0.shtml#req