×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

SCE Bootup Problem

Unanswered Question
Nov 28th, 2008
User Badges:

Hi Guys I have an SCE 2000 which failed after installation. the problem is i cant get access through the console, it does not respond. when i get access through the AUX port, the first prompt is [VxWorks Boot] if i try to reboot it gives the error cant load bootfile.

kindly assist

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Gustavo Paiva Fri, 11/27/2009 - 05:17
User Badges:

Hi everybody,


This is an old post, but I have the same problem... somebody knows how to boot the SCE from the VxWorks console?



Regards,

Gustavo.

gjaimes Thu, 02/04/2010 - 14:14
User Badges:

Hi Gustavo,


Did you get an answer to this problem?

I have the same problem !!!

Gustavo Paiva Fri, 02/05/2010 - 04:23
User Badges:

Hi,


First you need is a file named "SEos"... I looked for this file in the download area of Cisco could not find it.

Then the procedure is very similar to others using VxWorks...



Regards,

Gustavo.

miroslav.slavkov Wed, 06/30/2010 - 06:25
User Badges:

If you have a running box, you can extract the OS file and boot it with TFTP.

The file name is 'seos'.

russell.bean Fri, 09/30/2011 - 07:58
User Badges:

Hi, I have the same issue, but the network card doesnt boot, how can I get the management Ethernet interface to come up in the VX works boot mode so I can copy the seos file from another working device?

Actions

This Discussion