H-REAP and Non H_REAP AP's using the same SSID

Unanswered Question
Nov 28th, 2008
User Badges:

I have an existing network with Non H-REAP AP's and I am installing a remote office using H-REAP APs. I am using some of the same SSIDs on both sites and have enabled the H-REAP setting on the WLANs.

The design guide I looked at had this note;

Note: Access points not configured to operate in H-REAP mode ignore the H-REAP Local Switching setting and all client traffic is tunneled back to the controller.

It works OK and traffic is locally switching at the remote sites and still tunneling on the main site.

But am I breaking any design or supported options rule.


Toby.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Scott Fella Fri, 11/28/2008 - 07:16
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 Wireless

Nope... that is exactly how it was meant to be deployed. Most H-REAP install I have done uses a single ssid with some ap's in local and others in h-reap.

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode