cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
936
Views
9
Helpful
6
Replies

Cat6509E stuck in Rommon 1>

ney25
Level 2
Level 2

Hi Netpro,

i am stuck in Rommon , my cat6 can not bootup. need your advice .

thanks.

regard

jack

6 Replies 6

ergonullu
Level 1
Level 1

Get a suitable IOS from Cisco and boot from tftp which could be your laptop

http://www.cisco.com/en/US/products/hw/switches/ps663/products_tech_note09186a00800949c3.shtml

vishwancc
Level 3
Level 3

Hi Jack,

Where you doing some thin when it got into rommon.

I assume it is running hybrid IOS ,so is it rommon of SP or RP.

Give configregister value 0x2102 and reset.

Chao

Vishwa

Hi Vishwa,

this is sup 720 whereby someone itchy hand loaded wrong ios therefore causing switch cant boot up.

your reply will be highly appreciated.

thanks.

regards,

jack

see if u dont have this file and can help u.

U can use the procedure to copy right image from xmodem.

Hi Viyuan,

thanks for your doc. it was really helpful but i dont know why ? after new ios loaded and boot path have been setup as well. somehow when i reload , it's went back to Rommon 1> again. :(

your reply will be highly appreciated.

thanks.

jack

Hi Jack,

Can u please post the message it gives u before Rommon1 prompt

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: