Change IP Address of PGW2200

Unanswered Question
Nov 30th, 2008

Hi everyone!

I am an Junior in PGW 2200 configuration. Do I need to re-install PGW2200 when I change the IP Address of it?

Please give me any ideas?


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
tstanik Fri, 12/05/2008 - 11:49

The PGW refecence to his own ip address and to the IP address

of the standby PGW are all in the file :


In this configuration parameters

*.ipAddrLocalA =

*.ipAddrLocalB =

*.ipAddrPeerA =

*.ipAddrPeerB =

*.IP_Addr1 =

*.IP_Addr2 =

*.IP_Addr3 =

*.IP_Addr4 =

So you need to change this file in both the active and the standby PGW.

After the change the PGW application need to be restarted

In addition:

- all the NAS need to change the pointers to the

PGW addresses in they rlm-group configuration section

- all the SLTs need to change the pointer to the PGW IP address in the

"ss7 session" configuration section

After the change the SLTs neeed ot be rebooted.

Antonio Vicente Thu, 08/06/2009 - 08:14

no you dont need to re-install the PGW

just change the following files, to reflect the new IP addresses





This Discussion