cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
838
Views
0
Helpful
1
Replies

enable password forgotten in asa5510

miregistrocisco
Level 1
Level 1

Suppose I forget or loose the enable password, is there any way to recover or change it instead of loading the factory default configuration? Thanks in advance!

1 Reply 1

Fernando_Meza
Level 7
Level 7

Hi,

please see the below document

http://www.cisco.com/en/US/docs/security/asa/asa71/configuration/guide/trouble.html#wp1058131

You don't need to set the firewall to 'factory defaults' you only need to start it up on rom mode, get the config saved on flash back to memory, reset the password and then save the config from memory to flash again (it will include the new password you have just changed) change the config register .. and that's it. the link provide all the details

please rate helpful posts !!!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: