IPMA

Answered Question
Dec 1st, 2008

CTI route point is not registering. I was wondering if it was because of the CSS. I ran the wizard initially but i am not sure if i generated the CSS correctly. Can some onetell me which partitions should be in which CSS. or rather which should not be. Currently there are two CSS controlled by IPMA everyone and Manager. All partitions are in both CSS including the route-point partition.

I have this problem too.
0 votes
Correct Answer by Jaime Valencia about 8 years 1 month ago

this diagram shows how you should have them:

Figure 23-8 Unified CM Assistant Proxy Line Mode Dial Plan Example

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/srnd/7x/cmapps.html#wp1043992

HTH

java

if this helps, please rate

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.

Actions

This Discussion