×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

WCS Access Point Reboot versus Cold Boot

Unanswered Question
Dec 1st, 2008
User Badges:

I'm aware of the process an LWAP AP goes through when a cold boot is performed, specifically dealing with 1130 access points. I've noticed that when using the reboot command in WCS, the process is much shorter than a cold boot (unplugging the AP from power and network and then plugging everything back in).


So the question is - what is the difference between the reboot command in WCS and performing a cold boot? Does the AP retain some information during a reboot and therefore not require as much time to boot up?


Thanks for any help...

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
carenas123 Mon, 12/08/2008 - 07:25
User Badges:
  • Silver, 250 points or more

You can restart the access point by one of the following mehtods

1. Remove the power and replug the power cable

2. Using the CLI in the ap prompt type boot command. i.e [ap:boot]

3. In the Web interface use the System Configuration Setup page to restart the access point. Click Warm Restart System Now to perform a warm restart of the access point. A warm restart reboots the access point. Click Cold Restart System Now to perform a cold restart of the access point. A cold restart is the equivalent of removing and then reapplying power for the access point.



Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode