There was also another post a while back about the same thing. The workaround is as follows:

The only workaround is to uninstall flash player 10 and reinstall the latest flash player 9.0.124 from the Adobe web site by following these steps:

1. Get the version of the FlashPlayer you already have installed on your client machine by following this technote; http://www.adobe.com/go/tn_15507

2. If you are running FlashPlayer 10 or higher continue with this procedure, otherwise you can stop here, you do *not* need to proceed.

3. Download the FlashPlayer 9 archive zip file that contains the Flash Player 9.0.124 among the other versions (the version 9.0.124 is located in the 9r124 subfolder): http://fpdownload.macromedia.com/get/flashplayer/installers/archive/fp9_archive.zip

4. Un-install the existing FlashPlayer by following this technote: http://www.adobe.com/go/tn_14157

5. Reboot the client machine Operating System

6. Install FlashPlayer 9.0.124 by running one of the following files depending on the Operating System and Browser you are using;

Windows 9x/ME/NT/2000/XP

- Internet Explorer: flashplayer9r124_winax.exe

- Netscape & Firefox: flashplayer9r124_win.exe

Mac OS PowerPC

- flashplayer9r124_mac.dmg

Mac OS Intel

- flashplayer9r124_ub_mac.dmg.zip

Solaris

- flashplayer9r124_solaris_x86.tar.bz2 (for Intel x86 based client machines)

- flashplayer9r124_solaris_sparc.tar.bz2 (for Sparc based client machines)

7. (optional) Check that you have FlashPlayer 9.0.124 installed by following this technote : http://www.adobe.com/go/tn_15507

Hope this helps,

Gary.

This is no longer accurate. Cisco has a hotfix available to address this issue. Please open a TAC case requesting the Flash 10 hotfix.

As i said on my previous post above, Cisco offers a hotfix if you contact TAC.

However, with regards to the workaround for people who may not have TAC support (i.e in a lab environment), I tested it this morning and it does work.

Thank you for the advice. The workaround works fine and in the meantime I am asking our computer centre to contact TAC for the fix in case others have a similar problem and in case I in advertently upgrade to Flash 10..

I have further issues with Meeting Place. I would be grateful for assistance.

I understand the hotfix has been installed however I can no longer connect to Meeting Place, instead I get only as far as the page "Check our troubleshooting page for further assistance." If I run the browser test, it gives the message "Done" but does not execute the speed test as I see on other machines (ie I get the 3 green ticks but only then a single line).

I am unable to connect to Meeting Place even though the check tool reports OK. I note it does not run the speed test on the machine that does not work.