I set up a vpn connection and can connect. It will ask for the login and password then connects. But I can't ping or see anything on the network? Can anyone see what I am leaving out?
This is also set up to connect to two other locations.
It looks like you're missing some nat entries for your VPN Pool. IE access-list inside_nat0_outbound extended permit ip 192.168.2.0 255.255.255.0 172.16.1.0 255.255.255.0
Additionally I don't see a crypto ACL, however one is specified. IE access-list outside_dyn_map extended permit ip 192.168.2.0 255.255.255.0 172.16.1.0 255.255.255.0
Also reference the following document, I have it under my pillow :) : http://cisco.com/en/US/products/ps6120/products_tech_note09186a00807e0aca.shtml
Hope this helps, rate if it does.