just a small probem when changing administative distance

Unanswered Question
Dec 2nd, 2008
User Badges:

i am a student , i have three 2500 series router , serial connected r1 - r2 - r3 , and each router has three lan associated with each routers , i enabled both rip and igrp , then the routing table showed igrp router since the ad is low with rip , if i change the ad of igrp to 140 , then also igrp routes r shown , whats its cause , pls give me the exact command , thanks in advance

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
csco10716389 Wed, 12/03/2008 - 01:31
User Badges:

I will be showing in your routing table but check which one is the active route.

Laurent Aubert Sat, 12/06/2008 - 11:55
User Badges:
  • Cisco Employee,

Hi,


Use clear ip route * on all the routers to see if it changes something.


Thanks


Laurent.

Actions

This Discussion