cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
327
Views
0
Helpful
2
Replies

just a small probem when changing administative distance

binojbaby1984
Level 1
Level 1

i am a student , i have three 2500 series router , serial connected r1 - r2 - r3 , and each router has three lan associated with each routers , i enabled both rip and igrp , then the routing table showed igrp router since the ad is low with rip , if i change the ad of igrp to 140 , then also igrp routes r shown , whats its cause , pls give me the exact command , thanks in advance

2 Replies 2

csco10716389
Level 1
Level 1

I will be showing in your routing table but check which one is the active route.

Laurent Aubert
Cisco Employee
Cisco Employee

Hi,

Use clear ip route * on all the routers to see if it changes something.

Thanks

Laurent.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: