12-03-2008 07:59 AM - edited 03-06-2019 02:47 AM
What is the Command to disable Dynamic Trunking Protocol on a Catalyst 4006 Switch? I thought it was #switchport mode access, But It will not accept the word Switch as part of a command. Any Ideas??
Solved! Go to Solution.
12-03-2008 08:08 AM
James
Are you runnning IOS or CatOS. If IOS then are you using this command in interface configuration mode ie.
4500(config)# int gi4/1
4500(config-if)# switchport mode access
Jon
12-03-2008 08:08 AM
James
Are you runnning IOS or CatOS. If IOS then are you using this command in interface configuration mode ie.
4500(config)# int gi4/1
4500(config-if)# switchport mode access
Jon
12-03-2008 08:35 AM
Jon,
Thanks alot, that was right on the Money. The Tech I was working with did not go into the interface before entering the command.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: