Newbie Help

Unanswered Question
Dec 3rd, 2008
User Badges:

Can someone describe the steps you would take to configure a port on a Cisco 2960 switch so that the port would always trunk and the encapsulation would be non Cisco proprietary?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
MHTBruce1 Wed, 12/03/2008 - 13:58
User Badges:

Sorry would the same be true for the 2950? (Typo on the original) does that only support 802.1Q?

Jon Marshall Wed, 12/03/2008 - 14:29
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN


Yes the same goes for the 2950. In fact on these switches the "switchport trunk encapsulation " interface command is not available because there is no option ie. they both only support IEEE 802.1q.



This Discussion