12-03-2008 01:26 PM - edited 03-06-2019 02:47 AM
Can someone describe the steps you would take to configure a port on a Cisco 2960 switch so that the port would always trunk and the encapsulation would be non Cisco proprietary?
12-03-2008 01:42 PM
Cisco 2960 supports only 802.1Q encapsulation for the trunk (standards based)
eg
int f1/1
switchport mode trunk
switchport trunk native vlan [vlan-id]
Below is the configuration guide
HTH
Lejoe
12-03-2008 01:58 PM
Sorry would the same be true for the 2950? (Typo on the original) does that only support 802.1Q?
12-03-2008 02:29 PM
Bruce
Yes the same goes for the 2950. In fact on these switches the "switchport trunk encapsulation
Jon
12-03-2008 01:57 PM
...and thanks!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: