Can you transfer a call using UPC7.0?

Answered Question
Dec 4th, 2008

Is it possible to transfer a call that you are on when using UPC? I can't figure out how to do it.

Thanks.

I have this problem too.
0 votes
Correct Answer by Jonathan Schulenberg about 8 years 5 days ago

Yes but it's a little awkward.

1. Place your first call to party A.

2. Make a second call, this will put A on hold.

3. Once you are talking to B, press the Merge button on "A's" call control window. This will put you into a conference.

4. Hang up.

It should be noted that this uses a conference resource until you drop off. You'll need to ensure there are sufficient resources available.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Jonathan Schulenberg Fri, 12/05/2008 - 03:37

Yes but it's a little awkward.

1. Place your first call to party A.

2. Make a second call, this will put A on hold.

3. Once you are talking to B, press the Merge button on "A's" call control window. This will put you into a conference.

4. Hang up.

It should be noted that this uses a conference resource until you drop off. You'll need to ensure there are sufficient resources available.

j.mccartney Fri, 12/05/2008 - 07:42

Thanks it works great, the only thing different from your steps is that I had to press the Merge button on party-B to transfer the call. The merge button for party-A was grey'd out.

thanks again!

Actions

This Discussion