12-05-2008 11:43 AM - edited 03-15-2019 02:56 PM
Hi All,
We have a cisco 3845 router and we are trying to figure out,what all hardware/software components required to configure SRST on this router. Any help would be appreciated.
Thanks
Regards
Anantha Subramanian Natarajan
Solved! Go to Solution.
12-05-2008 12:42 PM
Anantha,
Depending on what you want to do, determine the number of DSP's you need. You could use the DSP Calculator for this:
http://www.cisco.com/cgi-bin/Support/DSP/dsp-calc.pl
Here's information on the DSP modules:
Hope this helps.
Thanks,
Michael.
12-05-2008 12:22 PM
Hi Anantha,
Here's the compatibility page which should provide the information you are looking for:
http://www.cisco.com/en/US/products/sw/voicesw/ps2169/products_device_support_tables_list.html
Regards,
Michael.
12-05-2008 12:26 PM
Hi Michael,
Thank you very much. I would assume the cisco 3845 router requires a PVDM2 and if so,do you have a comparison chart for it ?
Once again thanks
Regards
Anantha Subramanian Natarajan
12-05-2008 12:42 PM
Anantha,
Depending on what you want to do, determine the number of DSP's you need. You could use the DSP Calculator for this:
http://www.cisco.com/cgi-bin/Support/DSP/dsp-calc.pl
Here's information on the DSP modules:
Hope this helps.
Thanks,
Michael.
12-05-2008 12:45 PM
Hi Michael,
Thank you very much and have a nice day
Regards
Anantha Subramanian Natarajan
12-05-2008 12:56 PM
You're very welcome Anantha. Have a good weekend too.
Regards,
Michael.
12-05-2008 02:04 PM
Thanks Michael
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: