12-08-2008 04:48 AM - edited 03-18-2019 10:07 PM
I have a MCS7835H2 appliance that I booted and the UCM6 install has started. I want to do a factory restore on this so it is in original "out the box" condition. Is there a way I can do this ?
Solved! Go to Solution.
12-15-2008 07:28 AM
Sure; use your UCM6 install disc and run the install again. When it asks if you want to perform initial config, select no and power the system off once it cleanly shuts down. This is the state Cisco ships it to you in.
12-12-2008 07:16 AM
What troubleshooting has already been done? Is this a new install?
12-15-2008 07:28 AM
Sure; use your UCM6 install disc and run the install again. When it asks if you want to perform initial config, select no and power the system off once it cleanly shuts down. This is the state Cisco ships it to you in.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide