12-08-2008 10:27 PM - edited 03-09-2019 09:52 PM
Any way to allow access to FastEthernet interfaces but not GigabitEthernet interfaces using the privilege level command?
12-09-2008 12:00 PM
You would have to assign all of the interfaces manually for the privilege level that you want to allow access to. You could also assign a view if your device supports it.
HTH,
John
12-09-2008 06:52 PM
Hi John,
Thanks for your reply.
I applied the command "privilege configure level 10 interface FastEthernet0/1" but the user can also get into other interfaces. I discovered that whenever there is "privilege configure level 10 interface" in the command, no matter what follows, the user can access all interfaces, including FE, GE, Vlan, etc.
Any idea?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: