12-09-2008 06:03 AM
I have a multi-point wireless bridged link that needs to have all traffic encrypted over a vpn tunnel using the ASA 5505.
All ethernet segments are in the same address block as there is no reason to use different blocks as this is a bridged network.
Is this possible and if so, how do I set up the ASA's?
I have enclosed a diagram. I have also tried to explain to the customer that there is no need for the ASA's since I can encrypt all the traffic with the bridge's using AES, but they still want it.
Seth
12-10-2008 02:05 AM
Seth,
1) Is the "outside" interface of the ASA's on the same IP subnet?
2) Is the "inside" network on the ASA's all on the same IP network?
12-10-2008 05:40 PM
In this case, the inside interfaces of both ASA's would be in the same network. I can setup the outside interfaces to be in a separate network.
Seth
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: