12-10-2008 07:00 AM - last edited on 03-25-2019 03:21 PM by ciscomoderator
I am installing two 3845s with ATM and FrameRelay,at two Hub sites, replacing two 3825s. 40 Remote sites connect to both Hub 3845s. 1 primary PVC, 1 backup pvc. EIGRP neighbors keep resetting the hold uptime, about every minute. Putting the original 3825 back in at the primary Hub site fixes this problem. WAN circuits/interfaces check out fine, no errors. Is there a bug in EIGRP? ios ver on new 3845s is 12.4-9.T7. All the remote sites are 2500 series, 2600 series routers. Not sure why I can't get the neighbors uptime to stay up. Thank you.
12-10-2008 09:34 AM
Hello Paul,
there was another thread about a similar scenario.
Check your MTU settings on both ends the new hub and the remote sites
EIGRP updates have different sizes depending on the the prefix len : prefixes longer more specific then >= 24 use more bytes.
This makes possible cases where there is a problem in sending some updates and EIGRP neighbors keep resetting.
Hope to help
Giuseppe
12-12-2008 07:10 AM
Thank You Giuseppe
We will implement these changes next week.
We appreciate your help!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: