Hi
my sh int vlan output is below.It is not showing any info abt proxy arp .does that mean its disabled?
sh int vlan 88
Vlan88 is up, line protocol is up
Hardware is EtherSVI, address is 0013.5fa2.f000 (bia 0013.5fa2.f000)
Description: CISCO
Internet address is 10.248.88.6/24
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
ARP type: ARPA, ARP Timeout 00:04:00
Last input 00:00:00, output 00:00:00, output hang never
Last clearing of "show interface" counters 18w3d
Input queue: 2/75/399/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 1000 bits/sec, 2 packets/sec
5 minute output rate 16000 bits/sec, 13 packets/sec
L2 Switched: ucast: 160751241510 pkt, 19215835524246 bytes - mcast: 19999173 pkt, 2057553072 bytes
L3 in Switched: ucast: 58749 pkt, 4089353 bytes - mcast: 0 pkt, 0 bytes mcast
L3 out Switched: ucast: 394366724 pkt, 209012880801 bytes mcast: 0 pkt, 0 bytes
76537045 packets input, 10822323574 bytes, 0 no buffer
Received 19999149 broadcasts (5061148 IP multicast)
0 runts, 0 giants, 4 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
464834396 packets output, 221265441279 bytes, 0 underruns
0 output errors, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
Ullas
