12-11-2008 03:41 AM - edited 03-04-2019 12:40 AM
Hi ALL:
I have a 2 L3 switch which are connected to l2 Switch the L2 switch is again
connected to one more L2 and then to router.
I want to added a static route on both the L3 ,for which the next hop is router.
What configuration do i have to do on L3 and L2 switch for this to work.
L3---->L2---->L2----->Router
|
|
L3
L3 ARE CONNECTED TO EACH OTHER AS WELL AS TO L2.
Chao
Vishwa
12-11-2008 04:01 AM
Are they all in the same subnet or the two L3's are seperated by a seperate L3 link?
Narayan
12-11-2008 05:07 AM
Hi Narayan,
I am looking for a solution to pass my vlan x traffic to the router and all other traffic the the way it was going ,right now there is a default route pointing to the firewall on L3 for all the traffic the firewall is in between the L2 and for this solution i want to bypass the firewall as well so i have not inclued it in the diagram.
Chao
Vishwa
12-12-2008 01:48 AM
Hi Vishwa ,
"IP helper" could be the best way for you or configure Static route to each device.
HTH
DAk
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: