12-11-2008 11:39 AM - edited 02-21-2020 04:04 PM
Why there is a need to increase the tunnel interface bandwidth when running EIGRP with DMVPN?
Thanks,
Solved! Go to Solution.
12-12-2008 06:28 AM
The default value is 9. The recommend bandwidth value is 1000 or greater. Setting the bandwidth value to at least 1000 is critical if EIGRP is used over the tunnel interface. Higher bandwidth values may be necessary depending on the number of spokes supported by a hub. The bandwidth setting for the spoke does not need to equal the bandwidth setting for the DMVPN hub. It is usually easier if all of the spokes use the same or similar value.
Francisco
12-12-2008 06:28 AM
The default value is 9. The recommend bandwidth value is 1000 or greater. Setting the bandwidth value to at least 1000 is critical if EIGRP is used over the tunnel interface. Higher bandwidth values may be necessary depending on the number of spokes supported by a hub. The bandwidth setting for the spoke does not need to equal the bandwidth setting for the DMVPN hub. It is usually easier if all of the spokes use the same or similar value.
Francisco
12-14-2008 01:03 PM
by the way
bandiwdth with eigrp with dmvpn used for redundancy
while if u use ospf u can use link cost
hope this helps
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: