Conf Bridge CM 6.1

Unanswered Question

Trying to register a new Conf bridge with CM 6.1 and it shows Registration "Rejected". Here is the GW config. Ideas?

sccp local Loopback0

sccp ccm identifier 2

sccp ccm identifier 1



sccp ccm group 1

bind interface Loopback0

associate ccm 2 priority 1

associate ccm 1 priority 2

associate profile 10 register SIN-CONF


dspfarm profile 10 conference

codec g711ulaw

codec g711alaw

codec g729ar8

codec g729abr8

codec g729r8

codec g729br8

maximum sessions 2

associate application SCCP

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Brandon Buffin Thu, 12/11/2008 - 12:28

I'm not sure about "SIN-CONF". You might try removing the "-". Also, make sure the bridge name in CUCM matches this exactly.

Hope this helps.


Dennis Mink Wed, 12/17/2008 - 18:14

I experienced the same issue. Did you configure it as IOS enhanced conference bridge or just IOS conference bridge, which does matter.

also perform a shut/no shut on your profile 10


This Discussion